SPECIFICATIONS AND INSTALLATION INSTRUCTIONS
Stainless steel custom-made CLAMPING drain rings, CLAMPING drain bars and CLAMPING transition strips for resilient flooring systems
Existing Round Drains - Stainless Steel Drain Rings
At all existing round drains, install stainless steel drain rings of type as recommended by the flooring manufacturer, drilled and mechanically fastened over circular cut edge of resilient flooring, with the inside diameter that will allow clean out plate to be removed after installation. Install by drilling into substrate to accommodate lead or plastic anchors. Mechanically fasten tight with beveled head stainless steel screws.
Square and Rectangle Drains and Floor Sinks - Stainless Steel Drain Bars
At all existing square or rectangle drains and floor sinks, install stainless steel strips with a 45 degree angled cut on each side. Screws and plastic anchors must be installed according to instructions. refer to Stainless Steel Clamping Drain Rings.
Stainless Steel Transition Strips
At all door transitions, at raw edges of resilient flooring material, at edge transition to a dissimilar material, etc. Stainless Steel Strips must be specified. At no time should there be any raw edges on any resilient flooring, as this may cause water to seep under the resilient flooring, emulsify the adhesive and separate the resilient flooring from the sub-floor.
Installation Instructons
Place stainless steel clamping ring around the drain on the top of the resilient flooring, mark location of holes to be drilled using the appropriate type and size drill bit according to the subfloor, drill holes approximately 2"-3" deep. Insert the plastic anchor into the substrate. Place a bead of polyurethane caulking compound or adhesive underneath all stainless steel metal rings or bars prior to screwing down over the resilient flooring. Screw down the stainless steel ring or bar with the 2" screw provided for this use.
|
